Elasto Shield is a Clear Acrylic Elastomeric Sealant designed to seal and protect a wide range of surfaces including wood homes, stone, brick, masonry and concrete, roofing materials and reflective roof coatings.

All white roof coatings start losing their reflectivity properties due to accumulated dirt and other contaminates. Until now clear protective coatings for elastomeric base coatings were not available due to their lack of flexibility which is necessary as roof coatings are designed to expand and contract with a roofs movement.

Elasto Shield is based on the same resins used in our insulating roof coatings and features the same elongation, expansion and contraction properties of those coatings.

Elasto Shield also features outstanding adhesion to the applied surface, elongation and recovery capabilities, a combination of UV absorbers and mildewcides enabling it to resist the effects of the most severe climatic conditions.

Now all roof coatings can be protected from surface contamination enabling them to perform as intended by reflecting radiant heat away from the buildings interior. This self cleaning clear coat works much the same way as the clear coatings designed and used on automobile finishes.

Elasto Shield may also be used with TG Cells to give insulating properties to the surface as well.

Elasto Shield is truly an all-purpose clear sealant and protectant, suitable for virtually any application.

Color: Milky White, dries clear.
Volume Solids: 41% ± 2%
Flash Point: Same as water.
Coverage: 350-400 sq.ft. per gallon depending on the porosity of the surface.

Recommended Coverage: The number of coats depends on surface porosity; however, one coat is all that is normally needed on a well sealed surface.

 
Min. Surface Application Temp.: 7.2ºC / 45ºF. Do not allow to freeze.

Drying Time: Will depend on climate conditions. Allow at least 2 hours drying time between coats. First coat must be thoroughly dry before applying second coat.

Limitations; Not suitable for below grade use.
Surface Preparation: Surface must be clean and free from dirt, dust, grease, oil, mildew, wax, loose paint. Roof Shingles should be sealed with Therma Bond , our roof grade bonding/sealer for roofs to lock in loose granular minerals.

Application: Best applied by airless spraying or pump up type tank sprayers.

Can be applied with a short nap roller cover.

Clean Up: Cleanup immediately after use with soap and water.

CAUTION:
Do not apply within two hours of sunset, rain, fog or freezing temperatures. All coatings must be completely dry before exposing to water or foot traffic. Keep all containers covered when not in use. Keep away from children.

Available in 1 Gal, 5 Gal